Decking is also used for the design of aqua zones in landscape design - contours, streams, small bridges will look aesthetically pleasing, it is pleasant to walk according to the parquet and comfortable - its appearance is warm and does not fear water at all. Garden parquet is a square or rectangular tiles, joined together with fastenings.
The very name of the terracotta parquet is decking, it is connected with the aqua element. With the South American British, this translates to"deck". Decking has long been used for American and Canadian homes. Nowadays, we can decorate our own yard or veranda with this wonderful comfortable material. Decoration of the area by the pool with a terrace board. The aqua zone looks very presentable, and it's much nicer to walk according to the board with bare feet. it's warm. Excellent look for such a site will be and chaise lounges with umbrellas
Technical properties of this material
In the base of the decking board - wood-polymer composite, fixing additives, and polymeric consistencies (may exist as a synthetic, causeless and organic). As raw material for the production of decking used wood species of Siberian larch, cedar and such exotic trees, such as kumaru, teak, azob, reddish tree and merbau, more resistant to decay. Parquet from the wood species of tropical trees is much more expensive. The ecological purity of the material, the lack of harmful additives and impurities.
Giving is excellent
This parquet can be removed in the room, but the essence of its task - for the sake of creating a coating for the open air, the matter does not allow moisture to be prepared for the surface , to walk in accordance with it is not slippery./li>To lay the garden parquet is simple, for this, no special abilities are required,Longevity and strength. Decking withstands daily temperature fluctuations in front of 15 degrees, does not spoil the negative temperature, can withstand enormous loads - before 2 tons for a square meter.
Easy to clean. For the sake of decontamination through contamination, it is permissible to use special means or to wash it with a stream of hose. The coating does not need additional protection - paint, varnish, etc. Decking components are separate modules, it can exist like a terraced board, for no reason and tile.
A terraced board or tile - which is right for you?
A terraced board can exist smooth or own for the surface of the groove for the sake of anti-slip effect and drainage of water. The 2nd variation is better. The length of the board is 1.5 meters before 6 meters. The board can be of two types: with a hard and soft module. The soft board has a plastic frame. Special fastenings of the frame allow the modules to be quickly and efficiently combined with screws. Then the end of the work the structure of the coating looks solid, the fastening details are not visible. The boards of the rigid module are made of a continuous wood species resistant to moisture.
Decking is a tree species, perfectly adapted for outdoor use. Then the heat treatment - hot steam stripping without access to air, the tree acquires new characteristics - moisture is removed from it, it does not crack, does not dry out by exposure to sunlight, does not lose color, does not swell up to the highest humidity, it becomes easier.
But garden parquet is already a two-layer tile. The high discharge is lamellas (decking front panels), the lower one is the backing frame (can exist wood and plastic).
Features of installing the garden parquet
It was already mentioned, to mount the garden parquet comfortably and freely. For the sake of installation, it does not matter what kind of view - earth, gravel, gravel, tile, wooden floor. The installation of a garden parquet for a gravel base is a pre-aligned base, the tiles are connected by attachments for the designer's way. Probable variants of the picture - in this case, the change of horizontally and vertically arranged bands
A sand pillow like the base is not recommended to be removed - the tile is enough to sink into the dust, which will lead to uneven surfaces. To eat the types of decking, which, like a board, are attached to the lag.
If you have chosen the earth as a base, it should be eaten through weeds, pebbles and covered, if the weeds will try to germinate Through the cracks between the tiles, which can lead to deformation of the coating. It is more convenient to mount the garden parquet for a flat concrete base.
All the same for laying, no preparatory preparation of the base is required. Essence, so that the view was flat and the differences were less than 0.5 cm for a square meter). Laying parquet for a base of tiles - more artless and suitable variation. For a perfectly flat base, the terrace will last longer. load for fastening is small
Each parquet module has lock fasteners, which must be connected between themselves. This is done vividly, without reason, because of a couple of minutes it is allowed to collect a square meter of such coverage. If you need to leave the room for the protrusions, pipes, parts of the modules that interfere, you can simply block it with a saw.
Thorough installation action is presented for the video:
Development of the installation of the terrace board
The installation of the terrace board is done differently. The fixing of the board is done not for the base, but for supporting logs made of wood or plastic. Lags fit for a flat base - a tile or other matter.
The gap between the layers is 35-50 cm. The longer the board, the greater the gap between them, than the plate is shorter - the gap is smaller. Installation of a long terrace board for the lag. About lags there is a substrate for the sake of water flow. Some companies producing a terraced board, complete sets of special material for the sake of the substrate. If the coating is planned to be extracted in terms of the highest humidity, it is necessary to slip something hard, for example, clay tile near the lag. This will provide a drain of excessive moisture. It is allowed to determine the lags for the base with screws if you need such a need.
Put the first board for the lag, level it according to the edge of the lag. The board is attached to the lugs in a groove with a screw around the angle of 45 degrees. The first board can be strengthened to the lag by 2 methods:
1) into the groove with a screw
2) or the fastening clip also using a screw <
The clips are inserted into the grooves of the terrace board and for the lag, the clips are fastened to the lags by screws. The subsequent board must be interposed with a groove in the clip - similarly installed other boards. Then, like you fix the clip to the lagging screw, to the fixed board you can add the following, inserting its groove. For no reason, and continue before the end.
For the final finishing of the terraced board in accordance with the perimeter, it is allowed to remove stubs to hide the side slots of the last boards.
The terrace or the parquet from the garden parquet should be dismantled for the winter, if it is not laid for a lag near the open sky. The area from the terrace board laid out for the lag is allowed to cover with a film, and if it is placed near the canopy, it is not horrible at all. From the terrace board it is allowed to perform a kind of ordinary ground, for no reason and a rest area with several levels. For the creation of such a zone special,but such a mini-café will allow you to cook in a circle of friends and celebrate the festivities in your own garden near the open sky.
In case of dismantling, the tiles must be fairly eaten through dust, dirt, dry and select for storage sake a dry premise before the arrival of heat, if you can relax again for an outdoor playground.
Комментариев нет:
Отправить комментарий